Flat $5.99 shipping rate worldwide throughout May - no code needed! Start your design today. Flat $5.99 shipping rate worldwide throughout May - no code needed! Start your design today. Flat $5.99 shipping rate worldwide throughout May - no code needed! Start your design today. Flat $5.99 shipping rate worldwide throughout May - no code needed! Start your design today. Flat $5.99 shipping rate worldwide throughout May - no code needed! Start your design today.

EV-VNQ7040AY

Active

VNQ7040AY Evaluation Board

Quantity $ per Unit Savings
1 - 2$4.120%
Contact Sales
Out of stock
$4.12
Parameter NameParameter Value
Target ApplicationBody and Convenience
Core ProductVNQ7040AY
ECCN USEAR99
ECCN EUNEC
Packing TypeNot Applicable
ROHS Compliance GradeNot compliant
GradeIndustrial
Package NameCARD

This board provides you an easy way to connect STMicroelectronics® VIPower® M0-7 technology into your existing system.The board comes pre-assembled with VNQ7040AY high-side driver. On board, a minimum set of electrical components (as for device datasheet recommendation) is enabling the user to directly connect the load, the power supply and the microcontroller without any additional effort in external component design and connection. The VNQ7040AY is a quad channel high-side driver manufactured using ST proprietary VIPower technology and housed in PowerSSO-36 package. The device is designed to drive 12 V automotive grounded loads through a 3 V and 5 V CMOS-compatible interface and to provide protection and diagnostics. The device integrates advanced protective functions such as load current limitation, overload active management by power limitation and overtemperature shutdown with configurable latch-off. A FaultRST pin unlatches the output in case of fault or disables the latch-off functionality. A dedicated multifunction multiplexed analog output pin delivers sophisticated diagnostic functions including high precision proportional load current sense, supply voltage feedback and chip temperature sense, in addition to the detection of overload and short circuit to ground, short to V CC and OFF-state open-load. A sense enable pin allows OFF-state diagnosis to be disabled during the module low-power mode as well as external sense resistor sharing among similar devices.

Key features
  • Simple single IC application board dedicated for VNQ7040AYTR
  • Provides electrical connectivity and thermal heat-sinking for easy prototyping
  • General device features
    • Quad channel smart high side driver with analog
      feedback
    • Very low standby
      current
    • Compatible with 3 V and 5 V CMOS
      outputs
  • Diagnostic functions
    • Dedicated high precision proportional load current sense
    • Overload and short to ground (power limitation)
      indication
    • Thermal shutdown
      indication
    • OFF-state open-load
      detection
    • Output short to VCC
      detection
    • Sense enable/disable
  • Protections
    • Undervoltage shutdown
    • Overvoltage
      clamp
    • Load current limitation
    • Self
      limiting of fast thermal transients
    • Configurable latch-off on
      overtemperature or power limitation with dedicated fault reset pin
    • Loss
      of ground and loss of VCC
    • Reverse battery through self
      turn-on
    • Electrostatic discharge protection