Flat $5.99 shipping rate worldwide throughout May - no code needed! Start your design today. Flat $5.99 shipping rate worldwide throughout May - no code needed! Start your design today. Flat $5.99 shipping rate worldwide throughout May - no code needed! Start your design today. Flat $5.99 shipping rate worldwide throughout May - no code needed! Start your design today. Flat $5.99 shipping rate worldwide throughout May - no code needed! Start your design today.

IPS160HTR

IPS160HTR

IPS160H

Active

Single high-side switch

Quantity $ per Unit Savings
1 - 9$4.300%
10 - 24$3.8610%
25 - 99$3.6615%
100 - 249$3.1626%
250 - 499$3.0130%
500$2.7037%
Contact Sales
Out of stock
$4.30
Parameter NameParameter Value
ECCN USEAR99
ECCN EUNEC
Packing TypeTube
ROHS Compliance GradeEcopack1
GradeIndustrial
Package NamePowerSSO 12

The IPS160H (IOUT = 2.5 A) and IPS161H (IOUT = 0.6 A) are monolithic devices which can drive capacitive, resistive or inductive loads with one side connected to ground.


The 60 V operating range and Ron = 60 mΩ, combined with the extended diagnostic (Open Load, Over Load, Overtemperature) make the IC suitable for applications implementing the proper architectures to address higher SIL levels. The built-in overload and thermal shutdown protections guarantee the ICs, the application and the load against electrical and thermal overstress. Furthermore, in order to minimize the power dissipation when the output is shorted, a low-dissipative short-circuit protection (cut-off) is implemented to limit the output average current value and consequent device overheating.


Cut-off delay time can be set by soldering an external capacitor or disabled by a resistor on pin 4 (CoD). The DIAG common diagnostic open drain pin reports the open load in off-state, cutoff (overload) and thermal shutdown.

Key features
  • 8 V to 60 V operating voltage range
  • Minimum output current limitation: 0.7 A (IPS161H) or 2.6 A (IPS160H)
  • Fast demagnetization of inductive load
  • Non-dissipative short-circuit protection (cut-off)
  • Programmable cut-off delay time using external capacitor
  • Ground disconnection protection
  • VCC
    disconnection protection
  • Thermal shutdown protection
  • Undervoltage lock-out
  • Diagnostic signalization for: open load in off-state, cut-off and junction thermal shutdown
  • Designed to meet IEC 61131-2
  • PowerSSO12 package