📢 Promotion ends on Mar. 31st! Get FREE SHIPPING for your automotive project! Order now! 🛒

IPS4260LTR

IPS4260LTR

IPS4260L

Active

Quad low-side intelligent power switch

Quantity $ per Unit Savings
1 - 9$4.660%
10 - 20$4.1810%
Contact Sales
Out of stock
$4.66
Parameter NameParameter Value
ECCN USEAR99
ECCN EUNEC
Packing TypeTube
RoHs compliantEcopack2
GradeIndustrial
Package NameHTSSOP20

The IPS4260L is a monolithic high speed (FSW up to 250 kHz) device, which can drive four independent capacitive, resistive or inductive loads with one side connected to supply voltage. The channels can be parallelized to reduce power dissipation.


When connected to Vcc rail, four integrated catch diodes clamp the turn-off transients generated by inductive loads even with huge inductance; combined with proper external TVS connected to VCC or to GND the IC allows fast decay, too. Each channel is protected against overload or short circuit event: the intervention level can be set by an external resistor on ILIM pin .


Built-in thermal shutdown protects the chip against overtemperature even in case of short-circuit. If enabled, the integrated cut-off protection features a non-dissipative protection in case of overload; it limits both the output average current value and, consequently, the device overheating. Cut-off delay/restart can be programmed by external resistors on CoD pin; it can be disabled by shorting CoD to GND.


Two common diagnostic open drains pins (OL, for open load and FLT for cut-off and thermal shutdown) together with the four open drain on each INx pin (cut-off and thermal shutdown) feature an extensive diagnostic of the chip.

Key features
  • 8 V to 50 V operating voltage range
  • Four independent protected channels
  • VCC undervoltage lock-out
  • High speed operation (tr, tf < 1 μs)
  • Programmable load current limitation level by external resistor
  • Typical operating load current: 0.5 A (per channel) / 2 A (one channel)
  • Thermally independent junction overtemperature protections
  • Programmable non-dissipative short-circuit protection (cut-off) by external resistor
  • Open load (off-state) and short-to-ground activated by external pull-down resistors
  • Fast demagnetization of inductive loads with integrated catch diodes clamping turn-off transients
  • Ground and VCC wire break protection
  • VCC overvoltage protection
  • Common open load diagnostic
  • Common thermal shutdown and overload diagnostic
  • Per channel thermal shutdown diagnostic
  • Designed to meet IEC 61131-2
  • Miniaturized HTSSOP20 package