📢Shop now for EEPROM products with FREE SHIPPING code EEPROM-M95-FREESHIP. Check out our M95P32-IXCST/EF and M95P16-IXMNT/E today! 



Integrated Microprocessor driven device intended for LIN controlled exterior mirrors

Quantity $ per Unit Savings
1 - 9$8.690%
10 - 24$7.8610%
25 - 99$7.5014%
100 - 249$6.5125%
250 - 499$6.2129%
Contact Sales
In stock
Parameter NameParameter Value
Supply Voltage Min Volt-0.3
Supply Voltage Max Volt28.0
Operating Temp Min Celsius-40.0
Operating Temp Max Celsius150.0
Packing TypeTape And Reel
RoHs compliantEcopack2
Package NamePowerSSO 36

The L99MM70XP is a microcontroller driven multifunctional system ASSP dedicated for LIN controlled wing mirror applications. The device contains a voltage regulator to supply the microcontroller and a LIN2.1 physical layer. Up to 3 DC motors and five grounded resistive loads can independently be driven with four (five) half bridges and five high-side driver. The EC-glass control block provides overvoltage protection with a fast discharge path versus GND and a negative discharge path for future EC-glass characteristics. The integrated ST SPI controls all operation modes (forward, reverse, brake and high-impedance) and provides all the diagnostic information.

Key features
  • 5 V low-drop voltage regulator (150 mA max.)
  • Embedded LIN transceiver: 2.0/2.1 compliant and SAEJ2602 compatible
  • Independent control of mirror adjustment motors
  • One full bridge for 3 A load (Ron= 300 mΩ)
  • Two (three) half bridges for 0.5 A load (Ron= 1.6 Ω)
  • One configurable high-side driver for up to 1.5 A load (Ron= 500 mΩ / 10 Watt bulb control, or 1600 mΩ / LED control)
  • Two high-side driver for 0.5 A load (Ron= 1600 mΩ)
  • One low-side driver 0.5 A load (Ron= 1600 mΩ) used as half bridge with high-side driver for independent mirror axis control
  • One high-side driver for 6 A load (Ron= 90 mΩ)
  • One high-side driver for 0.5 A load (Ron= 1600 mΩ) to supply an external MOSFET to drive an EC-glass
  • Integrated EC glass control via an external MOSFET with fast discharge path: EC-glass can be discharged to GND or to -1 V
  • Programmable soft start function to drive loads with higher inrush currents (>6 A, >1.5 A)
  • Very low current consumption modes
  • All outputs short-circuit and overtemperature protected
  • Two thermal shutdown thresholds and early temperature warning
  • Current monitor output for all high-side drivers
  • Open-load diagnostic for all outputs
  • Overload diagnostic for all outputs
  • 3 PWM control signals for all outputs
  • Charge pump output for active reverse polarity protection via an external N-channel MOSFET
  • STM standard serial peripheral interface for control and diagnosis
  • INH input for external CAN transceiver