STEVAL-IDB012V1

Active

Evaluation platform based on the BlueNRG-LPS system-on-chip

Quantity $ per Unit Savings
1 - 500$58.800%
Contact Sales
In stock
$58.80
Parameter NameParameter Value
Core ProductBLUENRG-332AC
ECCN US5A992.c
ECCN EUNEC
Packing TypeNot Applicable
RoHs compliantEcopack2
GradeIndustrial
Package NameCARD

The STEVAL-IDB012V1 evaluation platform is designed to develop and test Bluetooth® Low Energy applications using the low power BlueNRG-LPS system-on-chip, in combination with inertial and environmental MEMS sensors, a digital MEMS microphone, and various interface buttons and LEDs.


The BlueNRG-LPS features a 64 MHz, 32-bit Arm Cortex®-M0+ core, 192 KB programmable flash memory, 24 KB SRAM, MPU, and an extensive peripheral set (4x PWM, I²C, SPI/I2S, SPI, USART, LPUART, and 12-bit ADC SAR).


The BlueNRG-LPS is compliant with the Bluetooth® Low Energy specification. It supports master, slave, simultaneous master and slave roles, data length extension, 2 Mbps, long range, extended advertising and scanning, channel selection algorithm #2, GATT caching, LE ping procedure, LE power control and path loss monitoring, and direction finding (angle of arrival/angle of departure) features.


Serial communication with a PC and three power options (USB only, battery only, and external power supply) allow complex application development and testing flexibility.

Key features
  • Bluetooth® Low Energy evaluation board based on the BlueNRG-LPS SoC in QFN32 package that supports:Master, slave, and simultaneous master-and-slave rolesLong range, 2 Mbps data rateDirection finding with angle of arrival (AoA) and angle of departure (AoD)Bluetooth
  • Uncompromised low-power radio performances:Up to +8 dBm programmable output power (at antenna connector)Excellent receiver sensitivity (-96 dBm @1 Mbps, -103 dBm @125 bps long range)Very low-power consumption: 3.4 mA Rx @ sensitivity level, and 4.3 mA Tx @ +0 dBm
  • Integrated PCB antenna, UFL connector for measuring equipment, and Arduino R3 connectors
  • Three power options: USB cable, battery, and external power supply
  • Associated BlueNRG-LPS development kit software package (STSW-BNRGLP-DK) including firmware and documentation
  • Three user LEDs and two user buttons
  • MEMS digital accelerometer/gyroscope
  • MEMS digital pressure/temperature sensor
  • Embedded CMSIS-DAP debugger and drag and drop programming support
  • RoHS compliant