📢 Special offer this month! Get FREE SHIPPING in 3-phase FOC BLDC motor control applications. no min. purchase or code required. Order now! 🛒

L99LDLH32TR

Active

32 channels LED driver with Automotive CAN FD Light interface

Quantity $ per Unit Savings
1 - 9$8.900%
10 - 24$8.0510%
25 - 99$7.6614%
100 - 249$6.6625%
250 - 499$6.3629%
500$5.8035%
Contact Sales
In stock
$8.90
Parameter NameParameter Value
Operating RangeAutomotive
Supply Voltage Min Volt5.5
Supply Voltage Max Volt28.0
Operating Temp Min Celsius150.0
Operating Temp Max Celsius-40.0
ECCN USEAR99
ECCN EUNEC
Packing TypeTape And Reel
RoHs compliantEcopack2
GradeAutomotive
Package NameVFQFPN 48 7x7x1.0 mm

The L99LDLH32 is a monolithic 32-channel linear current regulator specifically designed for automotive exterior O/LED rear lighting applications. Thanks to the high side configuration of the output channels, the L99LDLH32 is suitable to drive OLED panel with common cathode. It guarantees up to 35 V output driving capability - to cover the OLED forward voltage wide spread - and features 32 regulated current sources able to provide from 1 mA up to 15 mA individually programmable current to drive each pixel of the OLED panel independently. As the other device in the family (L99LDLL16), the L99LDLH32 integrates a robust purely automotive CAN FD Light compatible communication interface which allows a high rate data transmission (up to 1 Mbit/s) and uses CAN FD structure for long frames. Besides the CAN FD Light compatible physical layer, the device also integrates the protocol handler, so no additional external devices are needed to facilitate communication with Commander ECU. The L99LDLH32 can operate in bus mode using CAN FD Light compatible interface or in stand-alone/fail-safe mode using internal Few Time Programmable (FTP) memory registers.

Key features
  • AEC-Q100 qualified
  • General
    • CAN FD Light compatible Serial Interface, Protocol Handler, Draft Specification Proposal (DSP) available from CAN in Automation (CiA)
    • High precision oscillator integrated, no external quartz required
    • QFN48L 7x7 with exposed pad
    • Timeout watchdog with Limp Home
    • Low standby current
    • Stand Alone/Fail Safe and Bus mode operation
    • Direct drive (1 Direct Input), for 1 function group supporting ASIL requirements
    • Widest configurability by embedded non-volatile and volatile memories
    • Operating supply voltage range5.5 V – 40 V
  • Linear Regulators section
    • Operating temperature range- 40°C – 150°C
    • 32 constant current output channels, high side configuration
    • Output current from 1 mA to 15 mA, parallelable outputs
    • Output voltage up to 35 V
    • Feedback voltage to external pre-regulator, to optimize the regulation voltage minimizing overall power dissipation
    • Current setting per channel by 8-bit DAC
    • Analogue dimming, 8-bit PWM channel individual exponential brightness control and 8-bit global PWM dimming
    • Programmable PWM frequency
    • Slow turn on/off time, gradual outputs delay and dithered clock, for better EMC performances
  • Protection and diagnostic
    • Integrated 8-bit ADC, for full and flexible diagnostic
    • 1 dedicated line for fault bus
    • Temperature warning (1 threshold)
    • Over-temperature shutdown
    • Short circuit and open load detection and protection
    • Automatic LED current derating, through external NTC measurement and device junction temperature (TJ)