📢 Special offer this month! Get FREE SHIPPING in 3-phase FOC BLDC motor control applications. no min. purchase or code required. Order now! 🛒

STEVAL-IFP040V1

Active

Industrial digital output expansion board based on IPS1025HF in a QFN48L package

Quantity $ per Unit Savings
1 - 500$57.580%
Contact Sales
In stock
$57.58
Parameter NameParameter Value
Operating RangeIndustrial
Core ProductIPS1025HFQ
ECCN USEAR99
ECCN EUNEC
Packing TypeNot Applicable
RoHs compliantEcopack2
GradeIndustrial
Package NameCARD


The STEVAL-IFP040V1 is an industrial digital output expansion board. It provides a powerful and flexible environment for the evaluation of the driving and diagnostic capabilities of the IPS1025HF single high-side, smart power, solid-state relay in a digital output module connected to 2.5 A industrial loads.



The STEVAL-IFP040V1 can interface with the microcontroller on the STM32 Nucleo via 5 kV optocouplers driven by the GPIO pins and Arduino® UNO R3 connectors.



The expansion board can be connected to either a NUCLEO-F401RE or a NUCLEO-G431RB development board.



You can also evaluate a system consisting of an STEVAL-IFP045V1 stacked on an STEVAL-IFP040V1 expansion board.



Supplying the STEVAL-IFP045V1 through the main supply rail and the STEVAL-IFP040V1 through the output of the STEVAL-IFP045V1, you can achieve the typical architecture of a single channel digital output for safety systems. The process stages of the two expansion boards result cascaded. The load connected to the STEVAL-IFP040V1 output can be supplied only when both cascaded systems are properly working.


Key features
  • Based on the IPS1025HF single high-side switch, which features:
    • Operating range up to 60 V
    • Low-power dissipation (RON(MAX) = 25 mΩ)
    • Propagation delay at startup < 60 µs
    • Fast decay for inductive loads
    • Smart driving of capacitive load
    • Under-voltage lock-out
    • Overload and overtemperature protections
    • QFN48L 8x6 mm package
  • Application board operating range: 8-33 V/0-2.5 A
  • Extended voltage operating range (J3 open) up to 60 V
  • Green LED for output on/off status (J11 close 3-4 and SW5 close 1-2)
  • Red LEDs for overload and overheating diagnostics (SW2 and SW4 close 2-3)
  • Output voltage on/off status feedback (J11 close 1-2)
  • Control signal for fast discharge of output voltage (J11 close 5-6, J12 close)
  • External fast discharge circuitry for huge inductive loads (J11 close 7-8)
  • 5 kV galvanic isolation
  • Supply rail reverse polarity protection
  • Compatible with STM32 Nucleo development boards
  • Equipped with Arduino® UNO R3 connectors
  • CE certified
  • RoHS and China RoHS compliant
  • Not FCC approved for resale