📢Shop now for EEPROM products with FREE SHIPPING code EEPROM-M95-FREESHIP. Check out our M95P32-IXCST/EF and M95P16-IXMNT/E today! 

STEVAL-ILD003V1

Active

Analog wall dimmer for CFL/LED lamps based on the TS820 (EU version 220 V)

Quantity $ per Unit Savings
1 - 2$85.750%
Contact Sales
In stock
$85.75
Parameter NameParameter Value
Target ApplicationFluorescent Lighting
Core ProductTS820
ECCN USEAR99
ECCN EUNEC
Packing TypeNot Applicable
RoHs compliantEcopack2
GradeIndustrial
Package NameCARD

The STEVAL-ILD003V1 demonstration board is designed to propose a low-cost analog dimmer topology using a sensitive SCR TS820-600FP. The dimmer can drive typical low-consumption lamps, particularly CFL and LED dimmable lamps.


Through-hole technology is used for the most important components such as LC filter, gate resistor, turn-on delay capacitor, etc., in order to allow board modification, if needed.


The STEVAL-ILD003V1 eliminates flickering thanks to its continuous current applied through the sensitive SCR gate. This dimmer could easily replace a standard low-cost analog Triac light dimmer using a Diac-controlled circuit.

Key features
  • Operation for 2-wire wall dimmer
  • Leading-edge control (compatible with all lamps commonly found on the market)
  • Operation on 230 V line rms voltage (198 to 264 V) and 50 Hz or 60 Hz line frequency
  • Dimmable power range with halogen, CFL and LED lamps (without heatsinks mounted on SCRs1):
    • 3 to 350 W for 230 V rms line
  • Maximum operating ambient temperature: 60 °C
  • Power efficiency @ 350 W / 230 V > 99%
  • Standby losses @ 230 V < 0.5 W (could be reduced to 0 if potentiometer features a mechanical switch to open the circuit at minimum setting)
  • RoHS compliant
  • Compliance with EMC standards
    • IEC 61000-4-4: criteria A for more than 2 kV
    • Compliant with EN55015 with 350 W / 230 V halogen lamp
Associated Products