Free shipping worldwide on featured products - use code JUNE22_FREESHIP at checkout! Start your design today.Free shipping worldwide on featured products - use code JUNE22_FREESHIP at checkout! Start your design today.Free shipping worldwide on featured products - use code JUNE22_FREESHIP at checkout! Start your design today.Free shipping worldwide on featured products - use code JUNE22_FREESHIP at checkout! Start your design today.Free shipping worldwide on featured products - use code JUNE22_FREESHIP at checkout! Start your design today.

STEVAL-ILL066V2

Active

100 W LED street lighting evaluation board using the STLUX385A digital controller

Quantity $ per Unit Savings
1 - 2$147.000%
Contact Sales
In stock
$147.00
Parameter NameParameter Value
Target ApplicationLED Lighting
Core ProductSTLUX385A
ECCN USEAR99
ECCN EUNEC
Packing TypeNot Applicable
ROHS Compliance GradeEcopack2
GradeIndustrial
Package NameCARD

The STEVAL-ILL066V2 evaluation board is a complete and configurable solution that efficiently controls a single, dimmable, high-brightness LED string using the STLUX385A digital controller.


The LED efficiency is high during all stages of dimming: the STEVAL-ILL066V2 can achieve a 92% efficiency at full load while maintaining a low < 250 mW power consumption in idle periods and less than 500mW during failure (open or short).


The STLUX385A device handles a primary side regulated power conversion stage as well as all the supported communication links.


The power conversion stage consists of a PFC regulator followed by a “Zero Voltage Switching” (ZVS) LC resonant stage. The high precision dimming is adjusted using a primary side regulation (PSR) control technique.


The LED brightness can be dimmed by controlling the LED current down to a very low level.


The STEVAL-ILL066V2 evaluation board provides DALI, insulated 0-10 and UART physical communication interfaces, with all communication managed by the STLUX385A device.

Key features
  • based on STLUX385A digital controller
  • high efficiency (92%)
  • primary side controlled
  • up to 100 W (100 V at 1 A or 200 V at 0.5 A)
  • single isolated output suitable for LED connection
  • wide input voltage range: 90 V to 265 V AC
  • adjustable LED current and dimming
  • output resolution: 11-bit equivalent
  • IDLE mode power consumption: < 250 mW
  • real-time fault detection and protection (short-circuit or open circuit)
  • remote control via:
    • DALI ed.2.0
    • 0 - 10 V
    • UART
  • RoHS compliant