📢 New offer this month! Get FREE SHIPPING for your automotive project! Order now! 🛒

EVALST-3PHISOSD

Active

3-phase full shunt current meter evaluation board based on ISOSD61 and STM32F413RH

Quantity $ per Unit Savings
1 - 500$104.120%
Contact Sales
In stock
$104.13
Parameter NameParameter Value
Target ApplicationSmart Grid Distribution and Smart Meters
Core ProductSTISO621
ECCN USEAR99
ECCN EUNEC
Packing TypeNot Applicable
RoHs compliantEcopack1
GradeIndustrial
Package NameCARD

The EVALST-3PHISOSD evaluation board implements a complete 3-phase current meter with low-cost shunt current sensors.


The solution is based on the ISOSD61 device, a single channel, galvanically isolated, second order sigma-delta modulator, measuring current for each phase through a shunt current sensor. Sensing circuitry and PCB layout are optimized to maximize signal-to-noise ratio for optimal accuracy.


The ISOSD61 oversamples the signal using a clock (up to 15 MHz) distributed in a synchronized way by the microcontroller and outputs the current sigma-delta bitstreams.


The firmware embedded in the solution exploits the DFSDM filters of the STM32F413RH to convert the three bitstreams into 24-bit current data, at a selectable sampling rate.


The firmware also implements a virtual COM port communication to easily access the internal parameters to read data and to calibrate the board.

Key features
  • 3 channels current decimated samples available
  • Sampling frequency and measurement bandwidth selectable
  • Communication through USB in virtual COM port mode with shell commands
  • 6 kV galvanic isolation between the phases with 8 mm creepage and clearance